GPS-receiver 6870

System version:

Model 6870

GPS-snap-in module for rail installation.
The electronics are placed in a snap-in module made of aluminium. The voltage supply (18-60 V DC) and the 3 pulse outputs are connected by screw terminals. Signals of the serial interface (RS232, RS422) are led to a 9-pole SUB-D connector.
The module is fixed to the rail by means of a snap-in mechanism.
The software, which runs under MS Windows (3.x, 95/98, NT, 2000, ME) for the configuration and setup is included in the delivery.

As an option you can order the following interface configuration:

version 1: RS232/RS422
version 2: RS232/RS232
version 3: RS232/TTY passive
version 4: RS232/pulse output (1 pps)
version 5: RS232/RS422 a. IRIG-B pulse a. IRIG-B signal without DCF77-simulation
version 6: RS232/RS232-pulse

Technical Data

Receiver:	see GPS-Info
Voltage:	18-60 Volt DC, 3.5 VA
Housing:	measurements: 65 x 105 x 130 mm (WxHxD)
Interfaces:	serial interfaces with RS232 and RS422 hardware, baudrate 150-19.200, data bit, stopbit, parity, various data strings, DCF77-simulation 77,5 kHz, 3 programmable optically isolated pulse outputs, periodic, non-periodic pulses, system information
Supplied:	snap-action module FG687000, GPS-antenna with 25 m cable, configuration software for the setup (Windows 3.x, 95, NT), PC-adapter cable length: 1.5 m, documentation

Extras: antennas, antenna cables, lightning protection, line amplifier

Download Manuals / Software

Current manuals in english and german language and remote/service software resp. driver for our systems can be found in the download area:

homepage

+++ selection+++

top