Newsletter · Contact · Deutsch

Because every fraction of a second counts 

Go to timeserver.eu

hopf Logo

DIN Rail Converter 4800

Short Description

The hopf Signal Converter series 4800 for 35mm rail mounting (EN 50 022) is a low cost solution for the distribution/conversion of a variety of electrical and optical signals.

A choice of either DC or AC power supply units is available for the Signal Converter 4800.

hopf series 4800 Signal Converters with AC power supply have a wide input range in order to render them suitable for worldwide installation. Thus the device can be installed anywhere in the world without being prone to error when switching the AC input voltage range.

Numerous status LEDs for the signal inputs and outputs simplify diagnosis in the event of a fault.

Converters with customer-specific functions can be supplied on request.

Features

  • Robust aluminium housing
  • Designed for mounting on 35 mm rails in accordance with EN 50 022
  • Each signal input/output has its own status LED
  • All connection elements can be interlocked
  • Various power supply options are available:
    • AC - 100-240V AC (wide input range)
    • DC - 24V DC (18-36V DC) / 48V DC (36-72V DC) / 18-72V DC
    • Other voltages on request
  • Power supply unit with power LED
  • Completely maintenance-free

Customer-specific converter systems possible

Technical Data

Various variants are currently available (respectively with AC or DC power supply).

Converter 4800AC-14 / 4800DC-14 (RS422/RS232 ⇔ Optical Fiber)

Device 4800xx-14 is a full duplex optical fiber to RS422/RS232 interface converter.

Connection

  • The optical fiber transmitter (FL1) and receiver (FL2) are of the ST design.
  • The RS232 and RS422 signals are available on the 9-pole SUB-D male connector X1.
  • Power input is via the respective connector depending on whether the power supply is AC or DC.

Repeater Function

The optical fiber transmitters and receivers available in the converter can be connected to an optical fiber repeater by means of a connector on the RS422 interface.

Converter 4800AC-04/OC / 4800DC-04/OC (Optical Fiber ⇔ 3x Optocoupler)

Device 4800xx-04/OC is an optical fiber to optocoupler converter. With this converter, pulses can be transmitted over optical fiber and then emitted over optocoupler outputs.

Connection

  • The optical fiber receiver (FL) is of the ST design.
  • The 3 optocoupler outputs are available on the 9-pole SUB-D male connector X1.
  • Power input is via the respective connector depending on whether the power supply is AC or DC.

4800AC-11 / 4800DC-11 (RS422 ⇔ RS232) Converter

Device 4800xx-11 is a full duplex RS422 to RS232 interface converter.

Connection

  • The RS422 signals are available on the 9-pole SUB-D male connector X1.
  • The RS232 signals are available on the 9-pole SUB-D male connector X2.
  • Power input is via the respective connector depending on whether the power supply is AC or DC.

Pictures

Module 4800

Downloads

PDF documents

Software and Driver

  • For this product there is no Software / Driver available.